![]() ![]() The UP button on the remote is not working, but the wall switch is working. This is how you would handle the actual situation: ![]() That means: use the wall switch instead of the remote and vice versa. If none of the control mechanisms elicits a response from the screen, the circuit board is probably the issue because it’s unlikely that all three control devices would fail at once. Test the remote, the wall switch, and the trigger to see if they’re working. Defective Circuit BoardĬan you hear the motor when you turn on the projector screen even though the screen does not roll down or retract when you operate the controls? Once the motor stops working, the only solution is to get a new one.īefore spending money on a new one, and because a motor is a big purchase, have an expert look at it and confirm it’s dead and irredeemable. If the screen does not respond and you can’t hear the motor running, you likely have a defective motor. Switch on your motorized retractable screen and press the control button to roll the screen up and down. If you notice signs of damage on either part, replace it. Unscrew the bracket and examine it to see if it’s damaged. Lay the screen on a flat surface and open up the casing. If the roller or the bracket holding it in place is damaged, the screen may not retract at all. ![]() This should reset your screen’s tension, and the screen should operate as normal. If the spring is too tense and you want to loosen it a bit, turn the end cap anticlockwise. You should feel the tension increasing with each turn. Turn the end cap clockwise 12-15 times.Make sure that the square peg on the spring fits into the end cap. Place the left side end cap onto the spring.Keep rolling the rod until the screen is 100% folded into the casing. The aim is to roll the screen back into the casing. Locate the spring tension rod on the left side and manually turn it.Remove the end caps from both ends of the casing.If the spring is already too tense, exerting manual tension to try and get the screen to roll up will bear no fruit. And if you manually apply a bit of tension, it will retract.īut there’s another side to this problem. When the spring loses its tension, you’ll have a hard time moving the screen up and down. The force of the pull tugs at the roller, often jarring it into motion, and this jump-starts the screen retraction.Ģ. Pull the screen down an inch or two and then release it. The roller, which is the surface onto which the screen winds when you roll it up, spins in tune with the movement of the screen.Īnd sometimes, just like window blinds do, the roller will get stuck out of nowhere. There may be several explanations why your Elite Screens projector screen does not retract. You can control the motor using a remote or a wall switch. They also offer the option to set up the screen in spaces with no power outlets. However, some modern motorized screens come with rechargeable batteries, making the convenience of a wire-free connection a reality. For the motor to power up, you have to connect it to a power source, and for most motorized screens, this means connecting them to an electric outlet. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |